1725-LV Programmable Current Source (180mA to 900mA) 12V DC/AC Input, 0...10V dimming, motion and daylight


  • Programmable

    1725-LV output current is programmable between 180mA and 900mA using a trim potentiometer

    Ten pre-programmed intelligent behaviors may be selected on the program potentiometer.

  • LED drive capability 30 Watts

  • Can drive 9V...37V LED arrays or COBs.

  • 0...10V dimming option

  • Motion sensor option



1725-LV Programmable Current Source (180mA to 900mA) 12V DC/AC Input, 0...10V dimming, motion and daylight

1725-LV Flicker Free, Programmable Current Source (180mA to 900mA) Extra Low Voltage 12V DC/AC Input, 0...10V dimming, motion and daylight

This Extra Low Voltage 12V-AC or 12V-DC LED Driver is a 30W non isolated device with the following features:

  • Accepts 12V AC - 50/60Hz as well as 12V-DC
  • Output programmable between 180mA and 900mA
  • maximum LED drive capability 30 Watts
  • Suitable for wet locations when fully potted
  • Efficiency >87% over input voltage range
  • On / Off Touch Button functionality - 5 step DIMMABLE

The driver has 10 pre-programmed behaviors:

Programming:

Going from 0 to 1 back to 0 will toggle the active rest between 0% and 30% - the selection is indicated by the LED light output 0% = no light output and 30% = dim light output.
Program 1Motion control input is enabled, when triggered, a period of 10 seconds fully on, 10 seconds warning (50%) going to 0% or 30% active rest. The dusk to dawn (DD) sensor input is considered and if high (daylight) the motion input is ignored and the light output is 0%.
Program 2same as program 1 with motion enabled but a 1 minute interval, DD Sensor is considered.
Program 3 same as above but - 5 minute interval
Program 4 same as above but - 10 minute interval
Program 5same as above but - 15 minute interval
Program 6same as above but - 20 minute interval
Program 7same as above but - 25 minute interval
Program 8Motion disabled, DD disabled and 0-10V only
Program 9Motion disabled, DD enabled and 0-10V if night detected.
Program 10Motion and DD disabled - Touch Dimmer Only on Motion Input

Note: For touch dimmer applications (program 10) the sensitivity may have to be adjusted with an external resistor 50k..150kOhm between pin 1 and 2 of the motion input.

Chassis Ground may have to be connected to Signal Ground of the secondary side.

Order part numbers:

00-27-0725-1200 enclosed with flying leads for 12V power


Caution! All specifications published herein are subject to change without notice. See website ActiveLED.com for Terms and Conditions of use of the website and the information provided herein. See Ringdale website on www.ringdale-technology.com for Terms and Condtions of Sale and Service.

+1-833-850-7097
+44 (0)844 264 1570